A foot assist bar on the Discovery Series Selectorized Line Chest Press allows the user to begin exercise in an advantageous pre-stretch start position. The movement arm features a forward-set low pivot for proper motion path. The ratcheting gas-assisted seat adjusts easily and fits a wide range of users.
Equipment Features
Instructional placard | Easy to understand exercise placards feature large set-up and start and finish position diagrams that are visibly easy to identify. |
Upholstery | Premium-quality 3D urethane moulded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double topstitching on all seams. |
Rubber Feet | Yes |
Adjustments | Ratcheting seat adjustments require only a lift to release the lever. Handles include slip-resistant rubber sleeves with machined alloy end-caps. Adjustment points are highlighted with a contrasting colour for ease-of-use. |
Water Bottle and Accessories Holder | The drink and accessory holder features a large open, even surfaced area which is easily accessible and easy to keep clean. |
Bearings and Pivot Points | Oversized, linear, re-circulating ball bearings run on case-hardened shafts, and are sealed and self aligning. Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilising either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications. |
Pulleys and Cables | Glass-fibre reinforced nylon pulleys for durability, with precision motor grade ball bearing pulleys. All cables consist of 7 x 19-strand aircraft cable coated with black pressure-extruded nylon (either 3/16-inch cable coated to 1/4 inch or 1/8-inch cable coated to 3/16 inch). The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimise chance of external interference. |
Frame and Finish | The frame is 11 gauge (0.3 cm; 0.120 in) 2×10 cm (2×4 in) electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat. |
General Features | Movement arm features forward-set low pivot for proper motion path. Ratcheting gas-assisted seat adjusts to fit a wide range of users. Weight Stack 109 kg (240 lb). |
Equipment Specifications
Incremental Add-on Weight | 5 lb / 2.3 kg |
Standard Shroud Colour | Pacific Blue |
Weight Stack (kg/lb) | 240 lb / 109 kg |
Workout Area (L x W) | 163 L x 150 W / 64 L x 59 W |
Standard Frame Colours | Gloss Metallic Silver |
Stocked Upholstery Colours | All Spice |
Weight Stack(s)
Weight Stack(s) | Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish. Guide rods are precision centreless ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position. |
Equipment Dimensions & Weight
Length | 58 inches / 147 cm |
Width | 59 inches / 150 cm |
Height | 59 inches / 150 cm |
Machine Weight (base equipment) (kg/lb) | 530 / 240 |